• 2900 Product Data Guide
• 2900 Material Safety Data Sheet

Where to use: All exterior wood surfaces, such as decks, fences, siding, and outdoor furniture; and all types of wood such as redwood, cedar, fir, and pressure treated.

Surface Preparation: Do Not Apply Over Sealed Surfaces. All surfaces must be clean and free from dirt, mildew, soot, dust, and other foreign matter. Remove previous oxidized stains and sealers with Superdeck Wood Cleaner. New wood that has not been kiln dried must be allowed to season before applying product. New wood may be clean enough to directly apply stain. If not, or if wood has mill glaze, clean redwood and cedar surfaces with Superdeck Wood Brightener; clean pressure treated wood surfaces with Wood Cleaner. Weathered wood should be cleaned with Wood Cleaner and rinsed. For redwood and cedar, follow with Wood Brightener to remove tannin stains and brighten wood to its original color.

Product Preparation: Product should be stirred from bottom of container before and during application. Do not shake. Shaking will create excess air in product. If shaken, allow air to escape before application. When using more than one container of product, intermix all product and stir well to ensure color consistency.

Thinning: None required.

Application Methods: Apply product by brush, sprayer, roller, or pad applicator. Back rolling is suggested when spraying, working the product smoothly and evenly into the wood. This will decrease the possibility of pools and puddles on the surface and ensure a proper dry time and appearance of finish.

Application: Proper application is essential in order to accomplish the full benefits of product appearance and performance. Different wood species, textures, and natural color will affect finished shade. Always test a small area before doing entire job. When spraying, saturate surface leaving a wet sheen.  Then back brush or roll in a smooth even coat. Maintain a wet edge and apply product in entire board lengths to avoid lapping. Apply only as much product as the wood will absorb. Do not allow product to pool or puddle on surface. Thoroughly seal the porous ends of all boards with several coats of product.

Application Temperature: 50^OF. - 90^OF. Do not apply if wood surface is hot to touch or if rain is likely to occur.

Number of Coats: Apply only as much product as the wood will absorb. One coat is recommended for very smooth dense wood surfaces. Two coats are recommended for rough sawn or very porous wood surfaces.

Dry Time @ 77^O F: 1 hour to touch, 2-4 hours to re-coat, 24 hours for foot traffic. Dry time can be affected by species of wood, porosity of wood, wood moisture content, and weather conditions.